Zero-max ServoClass Coupling Manuel d'utilisateur télécharger pdf

ServoClass

Coupling Installation Guide

The ServoClass

coupling is a high performance coupling designed for precision

motion control applications. To maintain precise concentricity, the coupling is

assembled at the factory to precise tolerances using special fixtures.

As a result, the ServoClass

Coupling is not intended to be disassembled or

repaired in the field.

Installation Instructions*

1. Align the motor and the driven shaft before assembly; avoid

excessive misalignment between the shafts when installing

the coupling.

2. Examine shafts and clean if necessary. Shaft surface should

be clean, free of lubricants, corrosion or galling, etc.

3. Loosen, do not remove, the clamping screws on the coupling.

4. Mount the ServoClass

Coupling hub onto the driver motor shaft.

It is recommended that you do not tighten the clamping screw at

this point.

5. Carefully slide the other shaft into the clamp hub of the ServoClass

Coupling. It is recommended that you do not tighten the clamping

screw at this point.

6. Confirm the alignment of the connected shafts by rotating and

moving the coupling axially. If the coupling does not move freely,

the shaft alignment needs to be improved.

7. It is recommended that the shafts be in full contact with the entire

length of the coupling hub. The shaft may extend into the interior

of the coupling; however, the shaft ends should not touch or touch

internal stainless steel disc pack. Transmittable torque may be

compromised if shaft length is less than the length of the hub.

13200 Sixth Avenue North, Plymouth, MN 55441

Phone: 1-800-533-1731 Local 763-546-4300 Fax: 763-546-8260

ServoClass Rev 10/13 www.zero-max.com Page 1 of 2

1 2

Résumé du contenu

Page 1 - Coupling Installation Guide

ServoClass®Coupling Installation GuideThe ServoClass®coupling is a high performance coupling designed for precisionmotion control applications. To mai

Page 2 - *** for 4mm - 7mm bores

Clamp Screw / Tightening Torque Table8. After positioning the coupling to the optimal shaft-hub engagement,tighten the clamp screws to the specified t

Commentaires sur ces manuels

Pas de commentaire

Zero-max ServoClass Coupling Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Zero-max ServoClass Coupling. Zero-Max ServoClass Coupling User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Zero-max ServoClass Coupling